Rear Bush - Lower Arm

Bush - Lower Arm - Rear
Remove
1. Raise front of vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.





2. Remove nut securing lower arm rear bush housing and remove snubber rubber.

CAUTION: Note orientation of snubber washer.





3. Remove 2 bolts securing lower arm rear bush housing.
4. Release bush locating pin from body and remove bush housing.

Refit
1. Clean lower arm and bush housing mating faces.
2. Fit bush housing to lower arm and locate dowel into body.
3. Fit bolts securing lower arm rear bush housings and tighten to 105 Nm (77 ft. lbs.).
4. Fit snubber rubber and nut but do not tighten at this stage.

CAUTION: Ensure correct orientation of snubber washer. Ensure that "OUT" is visible on snubber washer when fitted.

5. Tighten rear bush housing nut to 140 Nm (103 ft. lbs.).

CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

6. Remove stand and lower vehicle.
7. Check front wheel alignment. Alignment