Front Bush - Lower Arm

Bush - Lower Arm - Front
Remove
1. Remove underbelly panel.
2. Raise front of vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.





3. Remove 2 bolts securing rear bush housing to rear beam.
4. Release rear bush housing from body dowel.
5. Remove bolt securing lower arm front mounting.
6. Release lower arm front mounting from rear beam.





7. Using LRT-60-008 and adaptors remove lower arm bush.

Refit
1. Ensure bush bore in hub is clean.





2. Using LRT-60-008 fit new bush into lower arm.
3. Align lower arm to rear beam, fit bolt but do not tighten at this stage.
4. Align rear bush housing to body dowel, fit bolts but do not tighten at this stage.
5. Tighten rear bush housing bolts to 105 Nm (77 ft. lbs.).

CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

6. Tighten lower arm front bush bolts to 190 Nm (140 ft. lbs.).
7. Fit underbelly panel.
8. Remove stands and lower vehicle.
9. Check and, if necessary, adjust wheel alignment. Alignment