Brake Rotor/Disc: Service and Repair

Brake Rotor/Disc

Service Repair No - 70.12.10

Remove
1. Raise front of vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

2. Remove road wheel(s).





3. Remove 2 bolts securing brake caliper to swivel hub.
4. Release caliper from disc and tie aside.

CAUTION: Do not allow caliper to hang on brake hose.





5. Remove 2 screws securing brake disc to drive flange.
6. Remove brake disc from drive flange.

Refit
1. Clean brake disc and drive flange mating faces.
2. Fit disc to drive flange, fit screws and tighten to 5 Nm (3.5 ft. lbs.).
3. Clean mating faces of caliper and hub.
4. Position caliper to brake disc fit bolts and tighten to 100 Nm (74 ft. lbs.).
5. Fit road wheel(s) and tighten nuts.
6. Remove stand and lower vehicle.