ACE - Front System Bleed

ACE - Front System Bleed

Service Repair No - 60.60.14

Introduction

CAUTION: The ACE hydraulic system is extremely sensitive to the ingress of dirt or debris. The smallest amount could render the system unserviceable. It is imperative that the following precautions are taken.
^ ACE components are thoroughly cleaned externally before work commences;
^ all opened pipe and module ports are capped immediately;
^ all fluid is stored in and administered through clean containers.

Remove

1. Switch on T4, select ACE diagnostic menu.
2. Turn ignition switch to the ON position.
3. Select the ACE bleed routine.
4. Check and if necessary, top-up fluid the ACE fluid reservoir.
5. Raise the vehicle on a four post lift.
6. Disconnect the ACE actuator links from the anti-roll bar.
7. Fully extend the ACE actuators.
8. Carry out the ACE bleed routine.
9. Connect the ACE actuators to the anti-roll bar.
10. Lower the vehicle.
11. Carry out the T4 ACE system response diagnostic routine.

Refit

1. Turn the ignition switch to the OFF position.
2. Exit the diagnostic routine and switch the T4 off.