Gasket - Rear Cover Plate

Gasket - Rear Cover Plate

Service repair No - 41.20.30

Remove





1. Mark rear cover to bearing housing for assembly purposes.
2. Note fitted position of stud nut, remove stud nut and 5 bolts securing rear cover.
3. Carefully release rear cover from bearing housing.

Refit
1. Clean rear cover, mating face on bearing housing and sealant from stud/bolt threads.
2. Apply sealant Part No. STC 3254 to rear cover mating face.
3. Align reference marks and position rear cover.
4. Apply Loctite 290 to stud/bolt threads, fit rear cover plate stud nut and bolts and tighten to 25 Nm (18 lbf.ft).
5. Top-up transfer box oil.