Interior - Cup Holder Squeaks
No: 76/05/99/NASRef:
Issue: 1
Date: 04/23/99
Lubricate Front Cup-holder
AFFECTED VEHICLE RANGE:
DISCOVERY Series II (LT) All
SITUATION:
SQUEAKS FROM CUP-HOLDER MECHANISM
Customers may experience squeaking from the cup-holder during use.
RESOLUTION:
LUBRICATE CUP-HOLDER MECHANISM
Upon customer complaint, verify source of squeak and perform procedure to lubricate cup-holder mechanism.
PARTS INFORMATION:
CYK100050 Krytox
WARRANTY CLAIMS:
76.13.89/32 Time 0.30 hrs.
Remove cup-holder and lubricate
$1.00 Material Allowance
FAULT CODE: K
Normal warranty policy and procedures apply
REPAIR PROCEDURE:
REMOVE AND LUBRICATE
1. Remove coin tray and ashtray.
2. Remove 6 screws securing cup-holder assembly to dash panel (Figure 1).
3. Remove cup-holder.
4. Apply Krytox in the following locations:
^ In the gear teeth
^ Along each side of the sliders
^ At the pivots
5. Check operation and lubricate other areas if required.
INSTALL
1. Position cup-holder assembly against dash panel and secure with screws.
2. Install ash tray and coin tray assembly.
3. Verify proper cup-holder operation after installation.