Front

LEGEND
(1) Anti-roll [Sway] Bar
(2) Rubber Bush
(3) Strap
(4) Nut, Bolt and Washer
(5) Nut and Washer
(6) Castellated Nut and Cotter Pin
(7) Ball Joint Link Arm

REMOVAL
1. Mark for reassembly position of rubber bushings on anti-roll[sway] bar.
2. Remove four nuts, bolts and washers (4) securing two bushings straps (3).
3. Remove nuts, bolts, washers and rubber bushings (5 & 6) from ball joint links and remove anti-roll[sway] bar (7).

INSTALLATION
1. Position bushings (2) on anti-roll [sway] bar (7).
- Ensure split points towards axle on RH bushings and away from axle on LH bushings.
2. Install anti-roll [sway] bar (7) with two straps (3).
- To ensure correct fit angled sides of bar should point down as shown.
- Loosely fit the bolts, washers and nyloc nuts(4).
3. Install bolt, washers and rubber bushings (5 & 6).
- Using new nuts fit anti-roll[sway] bar to ball joint links (7), then tighten to 68 Nm.
4. Tighten nuts (4) securing straps (3) to 30 Nm