Impact Sensor: Service and Repair

Crash Sensor - Pre 97 MY

Remove
1. Disconnect battery negative lead.
2. LH sensor only: Slacken power steering reservoir clamp and lift reservoir to provide access.
Diesel model only: Remove jack and mounting bracket.







3. Disconnect multiplug from sensor


CAUTION: Ensure airbag harness connector seal and anti-backout DO NOT come adrift when disconnecting sensor.


4. Use special socket, remove 2 screws securing crash sensor to body.
5. Remove crash sensor.

Refit
6. Reverse removal procedure.
7. Tighten crash sensor securing screws to 10 Nm.
Ensure multiplug is fully engaged on sensor and retained by its latch.
8. Check Supplementary Restraint System using Testbook.