Airbag Module - Passenger's

Airbag Module - Passenger's


WARNING: All the airbag system components, including the wiring harness, MUST be renewed after the airbags have deployed.


Remove
1. Switch off ignition.
2. Disconnect battery negative lead and then positive lead.







3. Open glovebox and disconnect harness connector from airbag module.
4. Use special socket and long extension, remove 2 torx head screws securing front of airbag module to fascia panel.
5. Use special socket, remove 2 torx head screws securing rear of airbag module to fascia panel.







6. Release airbag module from fascia panel.


CAUTION: Do not allow the airbag module to hang by the airbag harness.


7. Carefully and without pulling on connector remove airbag module.


CAUTION: Store the airbag module in accordance with the storage procedures outlined in Description and Operation.


NOTE: If airbag module is to be replaced the serial number must be recorded in the vehicle service record.


Refit
8. Reverse removal procedure.
9. Tighten airbag module securing screws to 8 Nm.


CAUTION: Take care not to cross thread screws.


10. Check Supplementary Restraint System using Testbook.