Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor (CKP Sensor)

Remove
1. Disconnect battery negative lead.
2. Raise vehicle on ramp.







3. Remove 2 bolts securing sensor/shield to engine backplate.
4. Remove sensor/shield.
5. Remove shield.
6. Disconnect sensor multiplug and remove sensor.
7. Remove spacer from sensor.


CAUTION: All vehicles have a spacer fitted to the sensor. Ensure spacer is correctly refitted.


Refit
8. Clean mating faces.
9. Fit spacer to sensor.
10. Position sensor and connect multiplug.
11. Position shield to sensor and align sensor/shield to engine backplate.
12. Fit bolts. Tighten to 6 Nm.
13. Lower ramp.
14. Reconnect battery negative lead.