Power Steering Line/Hose: Service and Repair

POWER STEERING PUMP AND STEERING GEAR

NOTE: The following procedures must be followed when installing fluid pipes to their components:

Installation
1. Remove plugs, place clamp on feed hose.





2. Push hose (2) onto pump.
3. Hold clamp (3) in position.
- Tighten to 3 Nm.
4. Fit high pressure union (4) into pump.
5. Hold pipe in correct position.
- Tighten to 20 Nm.





6. Remove plugs and install pipes (6) to steering box, leave finger tight.
7. Tighten as follows:
- 16mm thread 20 Nm.
- 14mm thread 15 Nm.

POWER STEERING RESERVOIR
1. Remove plugs and install pipes and clamps (1).





2. Tighten clamps to 3 Nm.