Procedures

DRIVE PLATE - AUTOMATIC
Service repair no -12.53.13


Remove
1. Remove automatic gearbox and torque converter.





2. Remove 4 clamp ring bolts. Collect clamp ring.
3. Remove flexible drive plate/starter ring gear assembly from hub aligner.
4. Remove 6 screws from hub aligner. Remove hub aligner from crankshaft. Collect spacer.
5. Check drive plate for distortion or cracks. Check starter ring gear for chipped or broken teeth. If either component shows signs of damage, fit a new assembly.


Refit
6. Ensure all mating surfaces are clean.
7. Fit spacer and hub aligner to crankshaft.
8. Fit hub aligner screws. Tighten to 85 Nm (63 ft. lbs.)
9. Fit drive plate and clamp ring.
10. Fit clamp ring bolts. Tighten to 45 Nm (33 ft. lbs.)
11. Fit automatic gearbox and converter assembly.