Thermostat - Rear

Thermostat - Rear

Remove
1. Remove evaporator/blower motor assembly harness.







2. Remove foam seal from evaporator to alpine light duct flange.







3. Remove screws securing 2 relay mounting brackets to evaporator/blower motor casing and position aside.
4. Disconnect 2 Lucars from thermostat.
5. Loosen 2 screws securing thermostat.
6. Release thermostat from bracket.







7. Remove 2 clips securing evaporator/blower motor casing halves.
8. Remove screw securing evaporator/blower motor casing halves.
9. Separate casing sufficiently to enable removal of thermostat probe from casing.
10. Remove thermostat.

Refit
11. Position thermostat fixings to casing and tighten screws.
12. Connect Lucars to thermostat.
13. Separate casing sufficiently to enable fitment of thermostat probe to casing.
14. Fit and tighten screw securing casing halves.
15. Fit clips securing casing halves.
16. Remove backing paper from NEW foam, evaporator to alpine light duct, flange seal.
17. Fit foam seal to evaporator/blower motor casing flange.
18. Fit evaporator/blower motor assembly harness.