With ABS

Rear brake discs, ABS

REMOVE

Sensor Ring:

1. Remove the rear hub assembly. Refer to Rear Hub with ABS Service and Repair
2. Remove the five Nyloc nuts.
3. Remove the sensor ring.
4. Remove the five hub to disc retaining bolts.
5. Remove disc from the hub.

REFIT

6. Fit disc onto the hub.
7. Apply Loctite 270© or equivalent, and fit the hub to disc retaining bolts. Tighten to 73 Nm.
8. Using new Nyloc nuts fit the sensor ring.
9. Check the total disc runout, this must not exceed 0.15 mm. If necessary reposition the disc.
10. Fit the hub assembly. Refer to Rear Hub with ABS Service and Repair