Rear

Rear Wheel Sensor - ABS:

NOTE: Numbers in parentheses ( ) below refer to numbers in illustration.

CAUTION: If a sensor is removed for any reason, a NEW sensor bush must be fitted.

REMOVAL
1. Disconnect battery negative lead.
2. Disconnect sensor electrical connections, located above rear axle.
3. Remove sensor from its locating clip.
4. Remove bolts securing mud shield (4).
5. Using a suitable lever, pry sensor from mounting bush (5).
6. Release harness cable ties, remove sensor lead from vehicle.
7. Remove sensor bush.

INSTALLATION
1. Install new sensor bush.
2. Lightly grease new sensor using silicone grease
3. Push sensor through bush until it touches exciter ring. Sensor will be 'knocked back' to correct position when vehicle is driven.
4. Secure harness in position (5).
5. Reconnect sensor electrical connection.
6. Drive vehicle to ensure ABS warning light is extinguished.