Drivers Side Fascia Access Panel - Installation

NO. 76/03/95/US

DATE: 13/1/95

MODEL
Discovery Range Rover

AFFECTED VEHICLES
1995 MY Range Rover, 1994 and 1995 MY Discovery

SUBJECT
Fascia Access Panel fitment-Drivers side

DETAIL

When a drivers side fascia panel (located under the fascia directly above the footwell pedals) is removed for any repair or inspection to be undertaken behind the fascia, it is important that prior to refitting, the fiber closing panel is inspected for tears or damage which could result in an insecure refitment. It should also be noted that NEW plastic fixings should be used as normally they will be damaged when removing which will render them unusable.

ACTION REQUIRED

When removing a fascia access panel, the panel should be inspected to ensure it is in good condition prior to refitment and new fixings MUST be used.

PARTS INFORMATION

BTR 9891 Fascia access panel - Left hand drive vehicles

BTR 9437 Plastic retention stud - 3 required

PROCEDURE





NOTE:
The illustration shown is for a Right Hand Drive vehicle. A left Hand Drive vehicle is the mirror image of this illustration.

Refer to the workshop manual section 76 for removal instructions.

NOTE:
Prior to refitment of a fascia access panel ensure refitment is not restricted by harness runs or other components which may affect the retention of the panel on its fixings.

A. Edge A must be located into the slot in the steering column.
B. Edges B must have no tears in these corners.
C. Edge C must be tucked behind the fascia.
D. Edge D must be tucked behind the fascia "A" post bracket.

Replace panel and secure with new fixings.

WARRANTY

Normal warranty policy and procedures apply.

COMP. CODE
8C3

5RO
76.46.40 Fascia access panel-renew-00.20 hour