Door Lock Cylinder: Service and Repair

Remove
1. Remove door trim.
2. Remove mounting panel. Service and Repair





3. Raise and support glass to gain access to latch mechanism.
4. Release spring clip and disconnect rod from lock operating lever.
5. Remove single screw and withdraw lock lever assembly.





6. Withdraw lock barrel from exterior door handle complete with locking sleeve.





7. To remove barrel from plastic retaining sleeve, depress spring loaded button and withdraw sleeve.


Refit

NOTE: If a new barrel is being fitted, check that number on barrel coincides with number on accompanying key.





8. Push plastic retaining sleeve over barrel until spring loaded peg locks it into position.
9. Fit barrel and plastic sleeve assembly to locking sleeve and insert into exterior handle reversing instruction 6.
10. Assemble lock lever components as illustrated and from inside of door panel, fit them to barrel assembly with single screw.
11. Connect operating rod to lock lever and secure with spring clip, reversing instruction 4.
12. Fit mounting panel.