Inspect and Overhaul

Throttle Linkage:

INSPECT AND OVERHAUL
1. Remove two retaining clips from spherical bush.
2. Remove the countershaft assembly.
3. If spherical bush is worn, drill out two securing rivets (4.7 mm, (3/16 in) diameter drill).
4. Split assembly, discard worn bush.
5. Grease new bush with Admax L3 or Energrease LS3. Assemble bush into housing. Assemble to throttle bracket using two 4.7 mm (3/16 in) diameter domed head rivets.

Throttle Linkage:

6. Examine bearing surface of countershaft assembly. If worn, fit new assembly, otherwise wind throttle return spring off levers.

Throttle Linkage:

7. Wind new spring onto countershaft assembly, small hooked end of spring is wound on first.
8. Grease shaft with Admax L3 or Energrease LS3, fit countershaft assembly to spherical bearing, secure with two clips.
9. Examine throttle stop lever for wear, fit a new lever if necessary.