Rear Wiper Motor

Rear Wiper Motor

Service Repair No - 84.35.12

Remove
1. With assistance, unscrew 3 retaining nuts and remove spare wheel from rear door mounting studs.





2. Lift wiper arm end cap to gain access to securing nut.
3. Remove nut and withdraw wiper arm from drive spindle.
4. Remove retaining nut, plain washer and rubber washer securing wiper motor drive spindle to door.
5. Remove 2 screws and remove cover from wiper motor mounting bracket.
6. Disconnect wiper motor harness multi-plug.
7. Remove bolt, with rubber washer, and remove wiper motor from rear door.

Refit
8. Locate wiper motor drive spindle through aperture in rear door.
9. Position wiper motor mounting bracket and secure to rear door. Tighten bolt to 23 Nm (17 ft. lbs.)
10. Reconnect harness multi-plug.
11. Secure drive spindle to door.
12. Fit wiper motor cover.
13. Align wiper arm to bottom of heater element and push arm onto spindle, tighten nut and tit end cap.
14. Fit spare wheel. Tighten retaining nuts to 130 Nm (95 ft. lbs.)