Sunroof Panel Seals

Sunroof Panel Seals

REMOVE
1. Position sunroof in the TILT position and disconnect battery negative terminal.
2. Unclip sunroof headliner from roof panel front and slide the sunroof headliner back fully.
3. Remove three roof panel screws from each side and remove panel.
4. Place the roof panel on a suitable surface to avoid damage and remove both seals.

REFIT
1. Position front seal to front edge of panel, ensuring that there is an equal length of seal each side of the center point. Secure seal using a rubber mallet.
2. Position the rear seal on one side immediately to rear of the front seal. Secure seal around panel edge ensuring a good fit around corners. Trim off excess seal at joint with front seal using suitable snips, ensuring that the joint is closed.
3. Refit the roof panel.