Auxiliary Front Crossmember

Front End Sheet Metal Repairs - Auxiliary Front Crossmember

Removal and Installation

Removal

- NOTE:
- This is a category 'B' repair.
- In this procedure the auxiliary front crossmember is replaced in conjunction with the:

- front bumper cover

1. Before commencing this procedure ensure that you are aware of all Health and Safety requirements.
2. For further information on the methods, tools and fixings used in this procedure refer to the body repairs - general information section.
3. Remove the front bumper cover







4. Remove the fan cowl.
5. Remove 4 10mm bolts, 2 each side, to the side member deformation element and remove the panel.

Installation
1. Offer up new panel, align and secure using the 4 10mm bolts, 2 each side. Tighten the bolts to 25 Nm (18 lb.ft).
2. Install is the reversal of removal.