Input Shaft Seal

Input Shaft Seal
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

NOTE:
Removal steps in this procedure may contain installation details.

All vehicles
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.


Vehicles with 5.0L NA or 5.0L SC engine
For additional information, refer to Transmission - 5.0L NA V8 - AJ133/5.0L SC V8 - AJ133 Removal

All vehicles





Special Service Tool




Holding Pins, Torque Converter, 307-613





CAUTION: Take extra care not to damage the edges of the component.

CAUTION: Discard the seal.

Special Service Tool




Slide Hammer, 100-012

Special Service Tool




Slide Hammer Adaptor, 100-012-01

Special Service Tool




Remover, Input and Output Seal, 308-375

Installation
All vehicles





CAUTION: Install a new seal.

Special Service Tool




Installer, Front Seal, 308-246





NOTE:
Make sure that the alignment mark is visible through the inspection hole as illustrated.

Special Service Tool




Holding Pins, Torque Converter, 307-613





CAUTION: Make sure the torque converter is fully located into the oil pump drive.

Vehicles with 5.0L NA or 5.0L SC engine
For additional information, refer to Transmission - 5.0L NA V8 - AJ133/5.0L SC V8 - AJ133 Installation

All vehicles
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect