Rear Toe Adjustment

Rear Toe Adjustment

CAUTION: LH illustration shown, RH is similar.

CAUTION: Make sure the vehicle is on a flat level surface.

CAUTION: Make sure the tire pressures are within specification.

CAUTION: Make sure that only the manufacturers' recommended four wheel alignment equipment is used.

CAUTION: Make sure the steering wheel is in the straight ahead position.
1 For wheel alignment information, refer to the suspension specification section. For additional information, refer to Specifications General Specifications
2 Check the tie rod ends, suspension joints, wheel bearings and wheels and tires for damage, wear and free play.
- Adjust or repair any worn, damaged or incorrectly adjusted components.
3 Check and adjust tire pressures.
4 Position the vehicle on a calibrated, level, vehicle lift.
5 Release the vehicle parking brake.
6 Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment.




7 To adjust, loosen the toe link locknuts.




8 Adjust the rear toe.
9
NOTE:
Use an additional wrench to prevent the component from rotating.
Tighten the toe link locknuts to 55 Nm (40 lb.ft).

10 Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment.