Rear Subframe: Service and Repair

Uni-Body, Subframe and Mounting System - Rear Subframe V8 5.0L Petrol/V8 S/C 5.0L Petrol

This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary

Removal and Installation

General Equipment

Powertrain Jack

Removal

- NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions.

2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.

3. Refer to: Fuel Tank Draining.
4. Refer to: Wheel and Tire.
5. Refer to: Driveshaft - 5.0L.

6. CAUTION: Be prepared to collect escaping fluids.

- NOTE:
- The fuel tank has a non-return valve in the filler stub pipe, only the fuel present in the filler hose will be spilt.
- Some variation in the illustrations may occur, but the essential information is always correct.

7. Using the special tool, press and hold the brake pedal.

8. WARNING: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

- CAUTIONS:
- Make sure that a new sealing washer is installed.
- Be prepared to collect escaping fluids.

- NOTE: LH illustration shown, RH is similar.

Torque: 35 Nm