Front Door Window Glass: Adjustments

Door Window Glass Adjustment

CAUTION: Protect the surrounding components.

NOTE:
Final door glass alignment or adjustment, can be carried out without the need to remove the interior door trim panel.
1 Check the alignment of the front door glass.
2 Open the door.




3 Remove the 4 screw covers.




4
NOTE:
This step is to align the door window glass to the nominal position and should be adjusted from this position to achieve correct seal engagement.
NOTE:
Do not apply excessive torque when the adjusters are at the end of their travel.
Using a 4mm Allen key, rotate the side adjusters clockwise until they reach the end of their travel.
- From this position, turn the adjuster screws counter-clockwise for 5 revolutions.




5 Make sure that the door window glass is aligned correctly to the seal as illustrated.
- If the alignment is incorrect, repeat Step 4 before carrying on with the procedure.




6
NOTE:
The glass must be in the lowered position to access the adjusters.
NOTE:
The glass should have 6mm +/- 2mm engagement into the upper seal, the glass may not have equal engagement when the 8mm door to rear quarter glass is set.
Using a extended 5mm Allen key, rotate the lower adjusters to adjust the glass height and achieve a parallel 8mm gap between the rear quarter and the door.
7 Install the screw covers.
8 Check the alignment of the front door glass.
9
NOTE:
For vehicles with convertible top, the door window function should be checked with the convertible top raised and lowered, to allow correct operation under all conditions.
When the window glass adjustment is complete the window motor will need to be calibrated, to do this power the window fully up and continue to hold the switch for a further 3 seconds.