Installation

Transmission
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary






CAUTION: Make sure that the torque converter remains in the transmission.

NOTE:
This step requires the aid of another technician.
Remove the torque converter retainer.





Torque to: 45 Nm





Torque to: 45 Nm
1 Remove the support.





Torque to: 127 Nm

CAUTION: Only rotate the crankshaft clockwise.
2 Make sure that the alignment mark is visible through the inspection hole on installation of the first torque converter bolt.





Torque to: 45 Nm





















Torque to: 10 Nm













Torque to: 48 Nm





Torque to: 6 Nm





Torque to: 40 Nm





3 Remove the special tool supporting the engine.





Special Service Tool




Engine Lifting Brackets Rear, 303-1436





For additional information, refer to Catalytic Converter Catalytic Converter
For additional information, refer to Transmission Fluid Cooler Tubes Transmission Fluid Cooler Tubes
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect