Tire Pressure Monitoring System (TPMS) Module [Convertible]

Tire Pressure Monitoring System Module

Removal
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications
2 Make the SRS system safe.
3 Remove the LH roll over protection unit.




4 Remove the rear seat RH backrest retaining bracket.
- Remove the 2 nuts and 2 bolts.




5 Remove the RH roll over protection unit.
- Disconnect the electrical connector.
- Remove the 4 Torx bolts.




6 Release the auxiliary junction box mounting bracket.
- Remove the 3 nuts.




7 Remove the tire pressure monitoring module.
- Remove the 2 nuts.
- Disconnect the 2 electrical connectors.

Installation
1 Install the tire pressure monitoring module.
- Tighten the nuts to 10 Nm (7 lb.ft).
- Connect the electrical connectors.
2 Secure the auxiliary junction box mounting bracket.
- Tighten the nuts to 10 Nm (7 lb.ft).
3 Install the rear seat RH backrest retaining bracket.
- Tighten the nuts and bolts to 10 Nm (7 lb.ft).
4 Install the RH roll over protection unit.
- Tighten the Torx bolts to 25 Nm (18 lb.ft).
- Connect the electrical connector.
5 Install the LH roll over protection unit.
6 Connect the battery ground cable and install the cover. For additional information, refer to Specifications
7 Using WDS, configure a new module.