Front Lower Arm

Front Lower Arm

Removal

CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the LH front wheel and tire. For additional information, refer to Wheel and Tire Service and Repair




3
NOTE:
Note the fitted position.
Release the forward lower control arm.
- Remove the 2 bolts and discard the nuts.

Installation
1 Install the forward lower control arm.
- Install the bolt and tighten the new nut to 60 Nm (44 lb.ft) + 135 degrees.
- Tighten the 14mm bolt to 175 Nm (129 lb.ft).
2 Install the wheel and tire. For additional information, refer to Wheel and Tire Service and Repair
3 Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment, and adjust if required.