Cooling Module

Cooling Module
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

NOTE:
Removal steps in this procedure may contain installation details.
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1 Raise and support the vehicle.
2 Evacuate the air conditioning (A/C) system.
For additional information, refer to Air Conditioning (A/C) System Recovery, Evacuation and Charging Air Conditioning (A/C) System Recovery, Evacuation and Charging
For additional information, refer to Cooling System Draining and Vacuum Filling Cooling System Draining and Vacuum Filling
For additional information, refer to Hood Service and Repair
For additional information, refer to Air Cleaner Outlet Pipe LH Air Cleaner Outlet Pipe LH
For additional information, refer to Air Cleaner Outlet Pipe RH Air Cleaner Outlet Pipe RH
For additional information, refer to Radiator Splash Shield Radiator Splash Shield









Torque to: 25 Nm





Torque to: 23 Nm





CAUTION: Make sure to protect the paintwork.

Torque to: 30 Nm









Torque to: 5 Nm













Torque to: 9 Nm









CAUTION: Make sure that all openings are sealed. Use new blanking caps.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.

Torque to: 8 Nm





Installation
1 To install, reverse the removal procedure.