Convertible Top Striker

Convertible Top Striker

Removal
1 Open the convertible top.
2 Remove the header rail upper trim panel. For additional information, refer to Header Rail Upper Trim Panel Service and Repair




3 Remove the header rail.
- Remove the 6 screws.




4 Remove the convertible to latch striker.
- Remove the 2 Torx bolts.
- Release the electrical harness clip.
- Disconnect the electrical connector.

Installation
1 Install the convertible to latch striker.
- Install the Torx bolts, but do not tighten fully at this stage.
- Connect the electrical connector.
- Secure the wiring harness clip.
2 Install the header rail.
- Tighten the screws.
3 Secure the convertible to latch striker.
- Tighten the Torx bolts to 23 Nm (17 lb.ft).
4 Install the header rail upper trim panel. For additional information, refer to Header Rail Upper Trim Panel Service and Repair
5 Close the convertible top.