Convertible Top Compartment Lid Release Cables

Convertible Top Compartment Lid Latch Cables

Removal





1
NOTE:
Support as necessary.
Open the convertible top to the position shown.
- Depress the switch.
2 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications
3 Remove the RH loadspace trim panel. For additional information, refer to Loadspace Trim Panel - Vehicles With: Convertible Top Loadspace Trim Panel [Convertible]




4 Release the convertible top electrical connector
- Release from the clip.
- Disconnect the electrical connector.




5 Release the LH convertible top lid latch.
- Remove the 3 bolts.




6 Release the convertible top lid position switch
- Remove the 2 Torx bolts.




7 Release the convertible top lid lift cylinder.
- Release the clip.




8 Release the convertible top lid lift cylinder bracket.
- Remove the 2 lower nuts.
- Loosen the upper retaining nut.




9 Release the convertible top latch release cables.
- Remove the 2 Torx bolts.
- Carefully release the 2 clips.





10 Release the convertible top lid lift cylinder bracket release cables.
- Loosen the 2 locknuts.
- Remove the clip.





11 Remove the convertible top lid release latch cables.
- Release from the 7 clips.

Installation
1 Install the convertible top lid release latch cables.
- Release from the 7 clips.
2 Attach the convertible top lid lift cylinder bracket release cables.
- Loosen the 2 locknuts.
- Remove the clip.
3 Attach the convertible top latch release cables.
- Secure with the clips.
- Tighten the Torx bolts.
4 Attach the convertible top lid lift cylinder.
- Secure with the clip.
5 Secure the convertible top lid lift cylinder bracket.
- Remove the 2 lower nuts.
- Loosen the upper retaining nut.
6 Secure the convertible top lid position switch.
- Tighten the Torx bolts.
7 Secure the LH convertible top lid latch.
- Tighten the bolts to 10 Nm (7 lb.ft).
8 Secure the convertible top electrical connector.
- Connect the electrical connector.
- Secure with the clip.
9 Install the RH loadspace trim panel. For additional information, refer to Loadspace Trim Panel - Vehicles With: Convertible Top Loadspace Trim Panel [Convertible]

10 Connect the battery ground cable and install the cover. For additional information, refer to Specifications

11 Close the convertible top compartment lid.

12 If required, adjust the convertible top compartment lid.