Instrument Panel Lower Trim Panel

Instrument Panel Lower Trim Panel

Removal





1 Remove the instrument panel end trim panel.
- Open the front door for access.
- Carefully release the 3 clips.




2 Remove the instrument panel driver's side reinforcement trim panel.
- Carefully release the 4 clips.




3
CAUTION: Care must be taken to avoid damage to the mating surfaces.
Carefully release and remove the rheostat switch assembly.
- Disconnect the electrical connector.




4
CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
Remove the driver's side footwell trim panel.
- Carefully release the 3 clips.




5 Release the MOST diagnostic port.
- Carefully release the clip.




6 Remove the instrument panel, lower trim panel.
- Remove the 3 Torx bolts.
- Remove the 2 Torx screws.
- Release the 2 clips.
- Release the vehicle diagnostic port.

Installation
1 Install the rheostat switch assembly and align the instrument panel lower trim panel.
- Secure the switch assembly clips.
- Connect the switch assembly electrical connector.
2 Install the instrument panel, lower trim panel.
- Install and secure the diagnostic socket.
- Align the clips.
- Install the Torx screws.
- Install the Torx bolts and tighten to 6 Nm (4 lb.ft).
3 Install the MOST diagnostic port.
- Secure the clip.
4 Install the driver's side footwell trim panel.
- Carefully align and secure the clips.
5 Install the instrument panel driver's side reinforcement trim panel.
- Align the pegs and secure with the clips.
6 Install the instrument panel end trim panel.
- Release the door aperture seal.
- Carefully align and secure the clips.
- Install the aperture seal.