Parking Assist Control Module: Service and Repair

Parking Aid Module

Removal

NOTE:
The park control module is situated in the LH footwell and does not change position with the hand of drive.
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications




2 LH side: Remove the cowl side trim panel.
- Remove the Torx screw.
- Remove the hood release lever.
- Release the forward edge of the scuff plate trim panel.
- Carefully release the clips.




3
CAUTION: Make sure the wiring harness and electrical connectors are not damaged during the carpet release.
Carefully release the carpet for access.
- Carefully release the forward edge of the floor console side trim panel.




4 Release the subwoofer cover.
- Remove the 4 bolts.
- Position aside.




5 Remove the parking aid module.
- Position the acoustic pad aside.
- Release 2 electrical harness clips from the body and position aside.
- Remove the 2 nuts.
- Disconnect the 2 electrical connectors.

Installation
1 Install the parking aid module.
- Connect the electrical connectors.
- Tighten the nuts to 3 Nm (2 lb.ft).
- Secure the electrical harness.
- Align the acoustic pad.
2 Install the subwoofer cover.
- Tighten the bolts to 10 Nm (7 lb.ft).
3
CAUTION: Make sure the carpet is correctly installed and that no foul-condition exists when the accelerator pedal is depressed.
Install the carpet.
- Install the floor console side panel trim.
4 Install the cowl side trim panel.
- Carefully align and secure the clips.
- Secure the scuff plate trim panel.
5 Connect the battery ground cable and install the cover. For additional information, refer to Specifications