Rear Parking Aid Sensor

Rear Parking Aid Sensor

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the rear bumper cover. For additional information, refer to Rear Bumper Cover Service and Repair




3 Remove the parking aid sensor.
- Disconnect the electrical connector.
- Release the 2 clips.
- Repeat the above for the other 3 sensors.

Installation
1
CAUTION: If a new sensor is installed, only the front face must be painted. Failure to follow this instruction may result in the component malfunctioning.
Install the parking aid sensor.
- Carefully secure the clips.
- Connect the electrical connector.
- Repeat the above procedure for the remaining 3 sensors.
2 Install the rear bumper cover. For additional information, refer to Rear Bumper Cover Service and Repair