Procedure 8 - Install Reinforcement Bracket to Rear (RH) Motor
PROCEDURE 8: V00477 - V10285NOTE:
Panoramic roof shown removed for clarity.
NOTE:
The RH rear grab handle must be removed for standard wheelbase (SWB) vehicles.
NOTE:
Rear (RH) motor located above RH rear grab handle.
1. Open Panoramic roof rear sun blind.
2. Remove Panoramic roof rear (RH) blind motor:
^ Remove two Torx bolts.
CAUTION:
Ensure any excess glue is removed from the casting prior to installation of the reinforcement bracket.
3. Inspect the casting assembly for excess glue; carefully remove as necessary.
NOTE:
New motor and casting assemblies have the reinforcement brackets already installed If the vehicle has had a new motor and casting assembly replaced as part of a previous repair, the reinforcement bracket may already be installed Do not install a bracket in this case.
NOTE:
Ensure the bracket is fully seated before reinstalling the motor.
4. Using pliers, squeeze the bracket into position to install the reinforcement bracket.
CAUTION:
Ensure the motor is located correctly on the dowels.
CAUTION:
Ensure the harness is located correctly above the motor; failure to do so will prevent the motor from locating correctly.
5. Install the motor:
^ Apply Loctite(R) 263 to the end of the threads of the Torx bolts.
^ Install and torque bolts to 4.0Nm (3.0lbf ft).
6. Continue to next appropriate Repair Procedure.