Convertible Top Tension Cylinder

Convertible Top Tension Cylinder

Removal
1 Release the convertible top front latches.
- Depress the switch.




2 Remove the convertible top hydraulic pump access panel
- Release the clip.




3
CAUTION: Do not loosen the Allen bolt more than 2 complete turns. Failure to follow this instruction may result in damage to the vehicle.
NOTE:
The ignition must be switched off.
Release the convertible top system pressure.
- Loosen the Allen bolt up to a maximum of 2 complete turns.




4 Release the convertible top compartment lid.
- Release using the cable.




5
NOTE:
Support as necessary.
Open the convertible top to the position shown.




6 Release the cylinder cover.
- Remove the 2 Torx screws.




7 Release the hydraulic cylinder.
- Release the 2 clips.
8
CAUTION: Fluid loss is unavoidable care must be taken to protect the interior of the vehicle.
Disconnect the hydraulic cylinder lines.
- Carefully release the 2 clips.
- Withdraw the hydraulic lines from the cylinder, remove and discard the O-rings.




9 Remove the hydraulic cylinder.
- Remove and discard the 3 cable ties.
- RH hydraulic cylinder only: Disconnect the electrical connector.

Installation
1 Connect the hydraulic cylinder lines.
- Lubricate and install the new O-rings.
- Connect the hydraulic lines to the cylinder.
- Secure with the clips.
2 Install the hydraulic cylinder.
- RH hydraulic cylinder only: Connect the electrical connector.
- Secure with cable ties.
- Secure with the clips.
3 Install the cylinder cover.
- Tighten the Torx screws.
4 Close the convertible top.




5
NOTE:
The ignition must be switched off.
Tighten the convertible top system pressure Allen bolt.
- Tighten to 2 Nm.
6 Install the convertible top hydraulic pump access panel
- Secure in the clip.
7 Operate the convertible top fully in each direction.
- Depress the switch.