Installation

Transmission
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.





CAUTION: Make sure that the torque converter remains in the transmission.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
1 Raise the powertrain assembly jack and transmission assembly.





NOTE:
Transmission shown removed for clarity.

Torque to: 48 Nm





Torque to: 48 Nm





Torque to: 48 Nm





Torque to: 45 Nm
2 Remove the support.





Torque to: 110 Nm





CAUTION: Only rotate the crankshaft clockwise.

NOTE:
Make sure that the alignment mark is visible through the inspection hole as illustrated.

Torque to: 63 Nm





















Torque to: 10 Nm





CAUTION: Install new o-ring seals

Torque to: 10 Nm









For additional information, refer to Catalytic Converter LH Catalytic Converter LH
For additional information, refer to Catalytic Converter RH Catalytic Converter RH
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect

NOTE:
For NAS vehicles only.
3 If required, carry out a long drive cycle.
For additional information, refer to Powertrain Control Module (PCM) Long Drive Cycle Self-Test Powertrain Control Module (PCM) Long Drive Cycle Self-Test