Front Lower Arm

Front Lower Arm

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the air deflector. For additional information, refer to Air Deflector Service and Repair
3 Remove the front wheel and tire. For additional information, refer to Wheel and Tire Service and Repair




4
NOTE:
Note the fitted position.
NOTE:
RH illustration shown, LH is similar
Release the front lower arm.
- Remove the 2 bolts and discard the nuts.

Installation





1
NOTE:
RH illustration shown, LH is similar
Install the front lower arm.
- Install the bolt and tighten the new nut to 60 Nm + 135 degrees.
- Install the front lower arm inner retaining nut and bolt, but do not fully tighten at this stage.
2 Install the front wheel and tire. For additional information, refer to Wheel and Tire Service and Repair
3 Lower the vehicle.




4
CAUTION: The final tightening of the front lower arm inner retaining nut and bolt must be carried out with the vehicle on its wheels
Tighten the 14mm bolt to 175 Nm.
5 Install the air deflector. For additional information, refer to Air Deflector Service and Repair
6 Lower the vehicle.
7 Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment, and adjust if required.