Rear Wheel Speed Sensor
Rear Wheel Speed Sensor
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The ignition must be switched off.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Disconnect the wheel speed sensor electrical connector.
3
CAUTION: Make sure that the harness retaining bracket is not removed. Failure to follow this instruction may result in damage to the harness.
NOTE:
Note the orientation of the clip.
Release the wiring harness grommet.
4
CAUTION: Note the fitted position of the component prior to removal.
Remove the wheel speed sensor.
- Remove the retaining bolt.
- Release the wheel speed sensor.
Installation
1
NOTE:
Make sure that the component is installed to the position noted on removal.
To install, reverse the removal procedure.
- Tighten to 6 Nm.