Campaign - ECM Update For MIL/DTC P0411

No: K050

Issue: 3

Date: 01 APR 2010

ISSUE "3" CHANGES ARE HIGHLIGHTED WITH A GRAY BACKGROUND AND SHOWN WITH ASTERISKS.

SECTION: 303

SERVICE ACTION: Engine MIL Illumination

AFFECTED VEHICLE RANGE:
XF (X250) 4.2L V8 Only VIN: R46314 - R65794
Model Year: 2010

CONDITION SUMMARY:

Situation:

On certain 2010 model year Jaguar XF vehicles equipped with the 4.2L V8 engine only, the engine Malfunction Indicator Lamp (MIL) may be illuminated with Diagnostic Trouble Code (DTC) P0411 stored in the Engine Control Module. The On-board diagnostic strategy may experience a false detection of Secondary Air Injection (SAI) performance (the calibration indicates an error exists with pump pressure or check valve operation where none exists).

NOTE:
Vehicles between R46314 - R63008 must be repaired in conjunction with RECALL J016.

Action:

Dealers are required to HOLD all affected vehicles within their control and refrain from releasing the vehicles for new or used vehicle sale pending completion of the rework action detailed in this bulletin. Sold vehicles should be repaired at the first available opportunity. Refer to the Repair Procedure outlined below to update the ECM software.

To identify repaired vehicles, US dealers must complete and install a Service Action 'Authorized Modifications' label on the radiator support panel.

California dealers are required by the California Code of Regulations to complete a salmon-colored 'Vehicle Emissions Recall - Proof of Correction' certificate. This form must be provided to the customer for vehicles registered in California when the Recall work has been completed.





PARTS





TOOLS





WARRANTY:

NOTE:
Always check DDW to verify that the vehicle is affected by this Recall Action or any other Service Action prior to undertaking any repair. DDW reflects only those vehicles affected and unrepaired.

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.

Warranty claims should be submitted quoting the Program Code 'K050' together with the relevant Option Code 'B' or 'C'; this will result in payment of the stated time. As Option Codes are used, there is no requirement to enter SRO information; these are displayed for information only. The option that allows for drive in / drive out may only be claimed if the vehicle is brought back into the workshop for this action alone to be undertaken.

REPAIR PROCEDURE

UPDATE THE ENGINE CONTROL MODULE SOFTWARE

CAUTION:
Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the vehicle.

CAUTION:
A Jaguar-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during diagnosis.

1. Connect the Jaguar-approved Midtronics Vehicle Power Supply to the vehicle battery.

NOTE:
IDS must be loaded with IDS-DVD120_V6.08 or later and Calibration File 29 or later.

2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

4. Select 'Diagnosis' from the Session Type selection screen.

5. Select the 'Selected Symptoms' tab, and then select:

^ Electrical > Instruments > Warning Lamps > Engine Malfunction Lamp > Lamp illuminated

6. Select 'continue'.

7. Select the 'Recommendations' tab.

8. From the Recommendations tab, select 'Run' to configure the 'Powertrain control module'

^ Follow all on-screen instructions to complete this task.

9. Exit the current session.

10. Disconnect IDS and the Midtronics Vehicle Power Supply from the vehicle.

11. US vehicles only: affix an Authorized Modification label to the radiator support.

12. California customer vehicles only: complete the CA Vehicle Emissions Recall - Proof of Correction certificate; hand to customer.

^ *As required by the California Air Resources Board, at the time a Proof of Correction certificate is issued to the customer, advise customer as described in the following statement: 'Please have this Proof of Correction certificate with you when renewing your registration as you may be required to present it to the Department of Motor Vehicles. Retain this certificate for your records.'*