Overhead Console
Overhead Console
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal
Vehicles without roof opening panel
1. Remove the retaining screw.
- Open the sunglasses compartment.
All vehicles
2. Detach the overhead console from bulb carrier retaining clips.
1. Release the overhead console to bulb carrier front retaining clips.
2. Release the overhead console to bulb carrier side retaining clips.
- Lower the overhead console.
3. Remove the overhead console.
- Disconnect the electrical connector.
Installation
All vehicles
1. NOTE: Do not remove the sunglasses housing from the overhead console.
Release the overhead console clips to aid correct installation of the overhead console to the headlining.
2. Connect the electrical connector.
3. NOTE:
- Make sure the headlining is correctly located in to the overhead console.
- Make sure the overhead console clips engage in the sunglasses housing.
Install the overhead console.
Vehicles without roof opening panel
4. Fit the retaining screw.