VIN Range: G00442->G45703

PINPOINT TEST G307559p4: C1165; RIGHT HAND REAR WHEEL SPEED SENSOR (WSS) ELECTRICAL FAILURE

G307559t14: CHECK THE WSS TO ABS/DSC MODULE SIGNAL CIRCUIT FOR HIGH RESISTANCE
1. Turn the ignition switch to the OFF position.
2. Disconnect the ABS/DSC module electrical connector EC30.
3. Disconnect the WSS electrical connector CV08.
4. Measure the resistance between EC30, pin 43 (W) and CV08, pin 02 (W).

^ Is the resistance greater than 5 ohms?

-> Yes REPAIR the high resistance circuit. For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No GO to Pinpoint Test G307559t15.

G307559t15: CHECK THE WSS TO ABS/DSC MODULE SIGNAL CIRCUIT FOR SHORT TO GROUND
1. Measure the resistance between EC30, pin 43 (W) and GROUND.

^ Is the resistance less than 10,000 ohms?

-> Yes REPAIR the short circuit. For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No GO to Pinpoint Test G307559t16.

G307559t16: CHECK THE WSS TO ABS/DSC MODULE SUPPLY CIRCUIT FOR HIGH RESISTANCE
1. Measure the resistance between EC30, pin 42 (N) and CV08, pin 01 (R).

^ Is the resistance greater than 5 ohms?

-> Yes REPAIR the high resistance circuit. For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No GO to Pinpoint Test G307559t65.

G307559t65: CHECK THE WSS TO ABS/DSC MODULE SUPPLY CIRCUIT FOR SHORT TO GROUND
1. Measure the resistance between EC30, pin 42 (N) and GROUND.

^ Is the resistance less than 10,000 ohms?

-> Yes REPAIR the short circuit. For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No INSTALL a new right-hand rear wheel speed sensor.
CLEAR the DTC. TEST the system for normal operation. If the DTC is repeated, contact dealer technical support for advice on possible ABS/DSC module failure.