G189073T1

G189073t1: CHECK FOR IGNITION FEED TO THE J-GATE
1. Disconnect the J-gate assembly electrical connector CA245.
2. Turn the ignition to the 'ON' position.
3. Measure the voltage at CA245 Pin 1 (GO).
^ Is the voltage greater than 10 Volts?
- > Yes
- > No
Repair the electrical circuit between the J-gate assembly electrical connector CA245 Pin 1 (GO) and the rear power distribution box FUSE 3. Clear the DTC. TEST the system for normal operation.

NOTE: This circuit incorporates the ignition switch and the primary junction box.