Shifter A/T: Service and Repair

Selector Lever (44.15.04)

Removal

1. NOTE: To move the selector lever, the ignition must be in the RUN position, with the foot brake pressed.

Move the selector lever to the 'N' position.
2. Remove the floor console.
3. Disconnect the electrical connector.





4. NOTE: The floor console bracket cannot be removed at this stage.

Remove the floor console bracket retaining screws.





5. Release the selector lever cable locking pin.





6. Disconnect the selector lever cable from the selector lever.





7. Remove the ashtray retaining screws.





8. Remove the ashtray.
Disconnect the cigar lighter electrical connector.





9. Remove the selector lever retaining screw.





10. Remove the selector lever.





11. Detach the electrical connector from the selector lever.





12. Remove the selector lever from the selector lever bracket.
Remove the selector lever retaining screws.





Installation

1. NOTE: Do not fully tighten the selector lever retaining screws at this stage.

Install the new selector lever to the selector lever bracket.





2. NOTE: The new selector lever is supplied with a setting tool installed, to hold the selector lever in the correct position for adjustment to be carried out.

NOTE: The setting tool must remain installed, until the selector lever cable adjustment has been carried out.

Set the distance between the selector lever pin and the selector lever bracket.
Adjust the distance to 97.5 mm (3.84 inches).





3. Tighten the selector retaining screws.





4. Attach the electrical connector to the selector lever.





5. Install the selector lever.





6. Install the selector lever retaining screw.





7. Install the ashtray.
Connect the cigar lighter electrical connector.





8. Install the ashtray retaining screws.





9. Connect the selector lever cable to the selector lever.





10. Install the selector lever cable locking pin.





11. Install the floor console bracket retaining screws.





12. Connect the selector lever electrical connector.





13. Set the selector lever cable adjustment.
14. Remove the selector lever setting tool.
15. Install the floor console.
16. Move the selector lever to the 'P' position.