Battery Reconnect Procedure

Battery Connect (86.15.15)

WARNING:
- Batteries normally produce explosive gases which may cause personal injury, therefore do not allow lighted substances to come near the battery. When charging or working near the battery always shield your face and protect your eyes. Always provide adequate ventilation. Failure to follow these instructions may result in personal injury.
- Batteries contain sulphuric acid, avoid contact with skin, eyes or clothing. Shield your face and protect your eyes when working near the battery to guard against possible splashing of the acid solution. In case of acid contact with the skin or eyes, flush immediately for a minimum of 15 minutes and seek prompt medical attention. If swallowed, call a physician immediately. Failure to follow these instructions may result in personal injury.

CAUTION: Make sure all electrical systems are OFF before connecting the battery ground cable. Failure to follow this instruction may result in damage to the vehicles electrical system.

1. NOTE: Petrol engine shown, diesel engine similar.

Connect the battery ground cable.







2. NOTE: Petrol engine shown, diesel engine similar.

Install the battery cover.







3. Enter the audio unit keycode and preset radio frequencies.
4. Reset the clock to the correct time.

5. NOTE: When the battery has been disconnected and connected the settings for the windows one touch facility and the anti-trap facility will have been erased.

Initialize the door window motors.

6. NOTE: When the battery has been disconnected and connected, the stored idle and drive values contained within the engine control module (ECM) will have been erased. The ECM must relearn the idle and drive values.

Relearn the ECM fueling adaptations.