G256924t35

G256924t35: CHECK THE ACCELEROMETER SENSOR SUPPLY CIRCUIT FOR HIGH RESISTANCE
1. Disconnect the front accelerometer electrical connector, EC13.
2. Disconnect the rear accelerometer electrical connector, TL34.
3. Measure the resistance between CR91, pin 16 (Y) and EC13, pin 03 (Y).
4. Measure the resistance between CR91, pin 16 (Y) and TL34, pin 03 (Y).
^ Is either resistance greater than 5 ohms?
-> Yes
REPAIR the high resistance circuit. CLEAR the DTC. TEST the system for normal operation.
-> No
CHECK for DTCs indicating a sensor fault. Contact dealer technical support for confirmation of possible module failure,
and/or raise an EPQR.