Bolster, Rear

Removal







1. Detach the center rear safety belt from the right hand safety belt stalk.







2. Remove the rear seat base.
- The safety belt buckles must be released from the seat before the seat is removed.
3. Remove the treadplate trim panel.







4. Remove the seat bolster.
1. Remove the nut.
2. Locate the locking clip to release the seat bolster.

Installation








1. CAUTION: Make sure that the seat bolster nut is not over tightened. Failure to follow this instruction may cause damage to the vehicle.


NOTE: Make sure the safety belt webbing and safety belt buckles are not twisted when installed.


To install, reverse the removal procedure.