Rear Seat Track

Rear Seat Track

Removal

1. Remove battery cover and disconnect ground cable from battery terminal.
2. Slacken and remove the two seat cushion front securing bolts and nuts.







3. Move the seat cushion forward to release it from the two frame rear tangs.







4. Disconnect the cushion heater harness multiplug and remove cushion from seat frame.







5. Remove and discard plastic scrivet securing lower end of side trim to inner wheelarch stud and withdraw trim from stud.







6. Push trim upwards to release keyhole aperture from squab fixing and partially withdraw trim for access.







7. Slacken and remove seat belt lower anchor securing bolt.







8. Carefully withdraw seat belt and anchor plate through trim aperture and escutcheon.







9. Remove side trim panel from vehicle.
10. Slacken and remove the seat squab outer securing bolt.







11. Slacken and remove the seat squab inner securing bolt.







12. Disconnect seat motor and squab heater harness multiplugs.







13. Slacken and remove four bolts securing seat frame to floor and remove seat from vehicle.







Installation

1. Position seat in vehicle and fit but do not tighten four bolts securing frame to floor.
2. Fit and fully tighten the two bolts securing squab frame to rear panel.
3. Fully tighten bolts securing frame to floor.
4. Connect seat motor and squab heater harness multiplugs.
5. Position side trim panel and carefully pass seat belt lower anchor through escutcheon and trim aperture.
6. Fit and tighten seat belt anchor securing bolt.
7. Position side trim and push downwards to engage keyhole on squab outer fixing.
8. Position trim lower end over stud and fit and fully seat new scrivet.
9. Position seat cushion for access and connect cushion heater harness multiplug.
10. Push seat cushion rearwards to engage it in rear securing lugs.
11. Fit and tighten cushion front securing bolts and nuts.
12. Connect ground cable to battery terminal and fit battery cover.
13. Return seat to original position.