Rear Seat Cushion Cover

Removal
1. Remove rear heel boards.
2. Remove rear seat cushion. Service and Repair
3. Place seat cushion inverted on clean work surface.





4. Remove and discard the eight hog rings securing cover at each seat belt anchor aperture.





5. Remove and discard hog rings securing outer edges of cover and cushion to frame.





6. Remove and discard two hog rings securing center panel overlap plastic edge fastener and release fastener from frame.





7. Withdraw center overlap through cushion for access and remove and discard hog rings securing horizontal seam of right hand panel to cushion.





8. Remove and discard the six hog rings securing right hand panel to center of cushion.
9. Remove and discard seven hog rings securing outer side of cover left hand panel to cushion.
10. Remove and discard the four hog rings securing horizontal seam of left hand panel to cushion.
11. Remove and discard the six hog rings securing securing cover left hand panel to center of cushion.
12. Withdraw cover from seat belt anchor apertures.
13. Remove cover from cushion.


Installation
1. Position cover on cushion.





2. Secure cover right hand panel to center of cushion using six hog rings.





3. Position cover right hand hand panel through cushion seat belt anchor aperture and secure horizontal seam to cushion using four hog rings.
4. Position cover and pass center overlap through cushion.





5. Secure outer side of cover right hand panel to cushion using seven hog rings.
6. Secure cover left hand panel to center of cushion using six hog rings.
7. Position cover left hand panel through cushion seat belt anchor aperture.
8. Secure horizontal seam of cover left hand panel to cushion using four hog rings.
9. Position cover and pass center overlap through cushion.
10. Secure outer side of cover left hand panel to cushion using seven hog rings.





11. Invert cushion assembly, fully seat cover center panel overlap plastic edge fastener on frame and secure with two hog rings





12. Ensuring even tensioning, secure outer edges of cover and cushion to frame using hog rings.





13. Position cover at seat belt anchor apertures and secure each with eight hog rings.
14. Fit rear seat cushion to vehicle. Service and Repair
15. Fit rear heel boards.