Squab

Removal
1. On vehicles with heated rear seat only, remove battery cover and disconnect ground cable from battery terminal. Service and Repair
2. Remove rear seat cushion. Cushion
3. Remove rear head restraints. Service and Repair





4. Slacken and remove outer seat belt lower anchor securing bolts.





5. Slacken and remove bolt securing center seat belt lower anchor plate and buckle cable to seat pan.





6. Remove seat belt escutcheon.
Using a flat-bladed screwdriver in the two rectangular apertures, carefully withdraw escutcheon from squab top roll.
Remove escutcheon from belt via split in moulding.





7. Slacken and remove the four seat squab securing screws.





8. Remove seat squab.
Lift squab clear of inertia reel assemblies withdrawing dowels from top panel.
Carefully feed seat belt anchor plates and tongues through squab apertures.
9. Disconnect heater element harness multiplugs (if fitted) and remove seat squab via rear passenger door.


Installation
1. Position squab in vehicle and pass seat belt tongues and anchor plates through apertures.
2. Lift squab top roll over inertia reel assemblies, locate dowels in panel apertures and lower and fully seat squab.
3. Fit and tighten the four squab securing screws.
4. Fit seat belt escutcheons to squab top roll.
5. Fit and fully tighten outer seat belt lower anchor securing bolts.
6. Fit and fully tighten bolts securing center seat belt lower anchor plate and buckle cable.
7. Fit rear cushion. Cushion
8. Fit rear head restraints. Service and Repair
9. On vehicles with heated rear seat only, fit ground cable to battery terminal and fit battery cover. Service and Repair